User’s Manual 9-27
Optional Devices
Connecting
1. Make sure the connectors are properly aligned and plug the i.LINK
(IEEE1394) cable into the computer.
Figure 9-25 Connecting the i.LINK (IEEE1394) port
2. Plug the other end of the cable into the device.
Note the following when you use i.LINK:
■ You may need to install drivers for your i.LINK devices.
■ Not all i.LINK devices have been tested. Therefore, compatibility with all
i.LINK devices cannot be guaranteed.
■ Some devices might not support standby or automatic off functions.
■ Do not connect or disconnect an i.LINK device while it is using an
application or when the computer is automatically shutting it down to
save power. Data might be destroyed.
Disconnecting
1. Open the Safely Remove Hardware icon on the Task Bar.
2. Point to i.LINK (IEEE1394) device and click.
3. Disconnect the cable from the computer then from the i.LINK device.
Bluetooth USB Adaptor
A Bluetooth adaptor that has a USB connector. Wireless communications
can be carried out with Bluetooth-compatible equipment by connecting to
the USB port of the computer.
You can buy the module from TOSHIBA dealer.
i.LINK (IEEE1394) port
i.LINK (IEEE1394)
connector
Refer also to the documentation that came with your i.LINK device.
To Next Page
Loading...
Need help?
General