High Wall, Heat Pump Type
Service Manual
54
Toshiba
8-22.Remote Controller and
Its Functions
8-22-1.Parts Name of Remote
Controller
1 Infrared signal transmitter
Transmits signals to the indoor unit.
2 button
Press the button to start operation. (A receiving beep is
heard.) Press the button again to stop operation. (A
receiving beep is heard.)
If the receiving beep isn’t heard from the indoor unit,
press the button again.
3 Mode select button (MODE)
Press this button to select a mode. Each time you press
the button, the modes cycle in order from A: Auto
change over control, : COOL, : DRY, : HEAT
and back to A.
(A receiving beep is heard.)
4 Temperature button ( )
...The temperature setting is raised to 30°C.
...The temperature setting is lowered to 17°C.
(A receiving beep is heard.)
5 Set horizontal air flow button (FIX)
Press this button to adjust the horizontal air flow
direction. (A receiving beep is heard.)
6 Set vertical air flow button (FIX)
Press this button to adjust the vertical air flow direction.
(A receiving beep is heard.)
7 Auto louver button (SWING)
Each time you press the SWING button, you can change
the swing mode. (A receiving beep is heard.)
(Vertical swing
→ Horizontal swing → Vertical and
Horizontal swing
→ Stop swinging)
Press the button again to stop the swinging mode. (A
receiving beep is heard.)
8 ON timer button (ON)
Use this button to change the clock and ON timer times.
To move up the time, press of the ON button.
To move down the time, press of the ON button.
9 OFF timer button (OFF)
Use this button to change the OFF timer times.
To move up the time, press of the OFF button.
To move down the time, press of the OFF button.
10
Reserve button (SET)
Press this button to store the time settings. (A receiving
beep is heard.)
11
Cancel button (CLR)
Press this button to cancel the ON timer and OFF timer.
(A receiving beep is heard.)
12
High power button (Hi POWER)
Press this button to start high power operation.
13
Memory button (MEMO)
Press this button to ready for storing the settings.
Hold down the button for 3 seconds or more to store the
mark is displayed.
14
Automatic operation button (AUTO)
Press this button to operate the air conditioner
automatically.
(A receiving beep is heard.)
15
SLEEP MODE button
Press this button to start sleep mode.
16
MY COMFORT button
Press this button to operate the air conditioner
according to the settings stored using the MEMO button.
17
PURE button (PURE)
Press this button to start the electrical air purifying
operation.
Press the button again to stop operation.
18
Fan speed button (FAN)
Press this button to select the fan speed. When you
select AUTO, the fan speed is automatically adjusted
according to the room temperature. You can also
manually select the desired fan speed from five
available settings.
(LOW , LOW+ , MED , MED+ ,
HIGH )(A receiving beep is heard.)
19
8°C operation button (8°C)
Press this button to start the 8°C set temperature
heating operation. (RAS-***-ND model only)
5
14
16
13
15
18
10
9
19
1
2
17
4
3
12
7
6
11
8
+00A08-010_01EN_SVM_HighWallHeatPump.book Page 54 Wednesday, March 4, 2009 11:22 AM
To Next Page
Loading...
