High Wall, Heat Pump Type
Service Manual
56
Toshiba
8-23.Hi POWER Mode
When [Hi POWER] button is pushed while the indoor
unit is in Auto, Cooling or Heating operation, Hi
POWER mark is indicated on the display of the remote
controller and the unit operates according to the
present operation mode as described below.
8-23-1.In Automatic Operation
The preset temperature changes according to the
operation mode selected.
In the Cooling operation, the preset temperature drops
by 1°C.
In the Heating operation, the preset temperature
increases by 2°C.
8-23-2.In Cooling Operation
(Manual)
The preset temperature drops by 1°C.
(The value of the preset temperature on the remote
controller does not change.)
8-23-3.In Heating operation
(Manual)
The preset temperature increases by 2°C.
(The value of the preset temperature on the remote
controller does not change.)
NOTE
• The Hi POWER mode can not be set in Dry
operation
• Release of Hi POWER mode:
Push [Hi POWER] button on the remote controller
again.
+00A08-010_01EN_SVM_HighWallHeatPump.book Page 56 Wednesday, March 4, 2009 11:22 AM
To Next Page
Loading...
