– 56 –
Terminal
cover
OL holder
P.C.board
support
Connector
Fan
motor
Compressor
(For unit B)
Compressor
(For unit A)
Parts position
RemarksProcedure
1) Remove the capacitor band. (Each 1 screw)
2) Disconnect the lead wire from the capacitor terminal.
1) Remove the electrical parts cover. (1 screw)
2) Remove the capacitor band. (2 screws)
3) Disconnect the lead wire from the capacitor terminal.
1) Remove the electrical parts cover. (1 screw)
2) Remove the transformer. (2 screws)
3) Disconnect the connector from the P.C. board
assembly.
1) Perform the process ‚ above.
2) Remove the terminal cover of compressor.
3) Remove OL holder and pull overload relay up.
4) Disconnect the lead wire from the overload relay
terminal.
No.
„
…
†
‡
Part name
Capacitor for
compressor
Capacitor for fan
motor
Transformer for
outdoor unit
Overload relay
To Next Page
Loading...
