Fan
motor
Compressor
(For unit D)
Compressor
(For unit C)
Parts position
RemarksProcedure
1) Perform the process ‚-1 above.
2) Remove the terminal cover of compressor.
3) Remove OL holder and pull overload relay up.
4) Disconnect the lead wire from the overload relay
terminal.
1) Perform the process •, ‚ above.
2) Remove the base plate (Right). (3 screws)
3) Remove the drain guide. (2 screws)
4) Remove the base plate (Left). (2 screws)
No.
‚-6
ƒ
Part name
Overload relay
Lower unit
*
The method of replacing parts of lower unit is the same as upper unit.
To Next Page
Loading...
