4.26 Fluorescent lamp 4 Replacement Procedures
Assembling the 15.0 Inch SXGA+ Sharp Fluorescent Lamp
To assemble the 15.0 inch SXGA+ Sharp fluorescent lamp, follow the steps below and refer
to Figures 4-139 to 4-153.
1. Stick four double-sided tapes (N, O, P, Q) on the P-chassis.
(P)
(Q)
(O)
Standard for edge of P-chassis
Do not make the P-chassis over this line.
0 to 1 mm
(N)
Figure 4-139 Replacing 15.0 Inch Sharp fluorescent lamp (SXGA+) (11)
Satellite A40 Maintenance Manual (960-458) 4-139
To Next Page
Loading...
