4 Replacement Procedures 4.4 Switch Cover and Hotkey board
Figure 4-14 Removing the hotkey board
Installing the Switch Cover and Hotkey Board
Install the switch cover and hotkey board according to the following procedures and Figures
4-13, 4-14.
1. Connect the SUMI-card to CN2000 on the hotkey board.
2. Place the hotkey board in the correct position.
3. Secure the hotkey board with the two M2.5x4 black flat-head screws.
4. Place the switch cover in the correct position and secure the following 11 latches, in
that order:
- Six bottom latches
- One latch on the left and right sides
- Three front latch
4-24 Satellite A60/ Pro A60 Maintenance Manual
To Next Page
Loading...
