Toshiba Satellite A60 - Display Assembly; Removing the Display Assembly

4 Replacement Procedures 4.7 Display Assembly
4.7 Display Assembly
Removing the Display Assembly
CAUTION: Use care to avoid that the antenna cable for antenna is caught between the
display assembly and computer.
Remove the display assembly with the top cover according to the following procedures and
Figures 4-19, 4-20.
1. Turn the computer upside down, and remove two M2.5x20 black bind screws,
Figure 4-19 Removing the screws from the bottom of the computer
2. Restore the normal computer placement and open the display panel.
3. Remove four M2.5x4 black flat-head screws and M2x3 white flat-head screw.
4. Disconnect the LCD/FL cable from CN13 on the system board.
5. Remove the wireless antenna cables from the hole.
6. Remove the display module.
4-30 Satellite A60/ Pro A60 Maintenance Manual