4 Replacement Procedures 4.12 System Board
Installing the System Board
Install the touch pad according to the following procedures and figure 4-29.
1. Place the slider for the kill switch on the system board.
2. Seat the system board and secure it with two M2.5x4 black flat-head screws.
3. Connect the hotkey board SUMI-card to CN8 on the system board.
4. Seat the HDD tray and secure it with one M2.5x4 black flat-head screw.
5. Press the kill switch button through the opening in the side. Be sure the prongs are
fully engaged.
4-44 Satellite A60/ Pro A60 Maintenance Manual
To Next Page
Loading...
