Toshiba TDP-WX5400 - Others; Trouble Indications; On;Standy Led; Status LED

74
75
Others
Trouble indications
The indicator lights to inform you of internal abnormalities.
ON/STANDY LED
Projector Status LED
Condition
LED Sequence Projector
Condition
AC Off Blank Off
Cooling Orange Blink 0.5 sec On
g
0.5 sec Off After Power Off
Power Up Sequence Green Blink 0.5 sec On
g
0.5 sec Off Power Up
Standby / Idle Orange On On
Power On Green On On
Status LED
Projector Status LED Condition LED Sequence Projector
Condition
Normal Condition Off Off Power On
Cover ERROR Blink Red once
(repeat)
0.5 sec On
g
2.5 sec Off ERROR
Temperature
ERROR
Blink Red twice
(repeat)
0.5 sec On
g
2.5 sec Off
x 2 times
g
2.0 sec Off
ERROR
Power ERROR Blink Red 3 times
(repeat)
0.5 sec On
g
2.5 sec Off
x 3 times
g
2.0 sec Off
ERROR
Fan ERROR Blink Red 4 times
(repeat)
0.5 sec On
g
2.5 sec Off
x 4 times
g
2.0 sec Off
ERROR
Key lock Active
(when key pressed)
Orange On Key lock Active
Idle Green On On
Lamp LEDs
Projector Status LED Condition LED Sequence Projector Condition
Lamp Off Off Off Always
End of Lamp Life Red Blink 0.5 sec On
g
0.5 sec
Off
Always
No Lamp Blink Red once
(repeat)
0.5 sec On
g
2.5 sec
Off
ERROR
Lamp ERROR Blink Red 6
times (repeat)
0.5 sec On
g
2.5 sec
Off x 6 times
g
2.0 sec
Off
ERROR
Cooling Lamp Orange Blink 0.5 sec On
g
0.5 sec
Off
Switching lamp 1 and
2
Re-light Up
Sequence
Green Blink 0.5 sec On
g
0.5 sec
Off
Power Up
Lamp Life Over
(cannot turn on)
Red On On Always



Others
ON/STANDBY STATUS LAMP1 LAMP2
If you think something is wrong, check the followings before contacting customer service.
Please see “Trouble indications”
p.74
as well.
If This Happens Check
No power Is the power cord plugged in? Is it connected to the projector?
Is the main power switch turned on?
p.36
Is the lamp cover attached properly?
p.67
•
•
•
Power goes out
during use
Is the ambient temperature high?
p.74
Is the air intake or air exhaust blocked?
p.74
•
•
No picture
Is the correct source selected?
p.38
Is the mute function on?
p.43
Is the brightness setting minimized?
p.50
Are the connections set up correctly?
p.28
Are all the connected devices functioning properly?
•
•
•
•
•
No audio
Is the mute function on?
p.43
Is the volume setting minimized?
p.40
Are the connections set up correctly?
p.28
Are all the connected devices functioning properly?
•
•
•
•
Picture not
displayed
correctly
Is the input signal supported by the projector?
p.78
Is there something generating an abnormal video signal, for
instance the video tape?
•
•
Picture blurred
Part of picture
out of focus
Is the lens dirty?
p.70
Is the lens focus adjusted optimally?
p.39
Is the projection distance within the supported range?
p.26
Is the projector’s screen placement angle tilted too far?
p.26
Are the sharpness or phase adjustments off?
p.50
p.53
•
•
•
•
•
Image is dark
Are the brightness or contrast adjustments off?
p.50
Is the lamp nearing the end of its service life?
p.59
•
•
Colors too light
Bad shading
Are the color, tint, R-level, G-level, or B-level adjustments off?
p.50
p.51
Is the screen dirty?
Is the lamp nearing the end of its service life?
p.59
•
•
•
Control panel key
doesn’t work
Is the key lock function on?
p.56
•
Remote control
doesn’t work
Are the remote control’s batteries drained?
Are the batteries inserted into the remote control correctly?
p.23
Is the remote control being used within the effective range?
p.23
Are there any obstructions between the remote control and
projector?
Are there any uorescent or other bright lights shining at the
projector infrared remote sensors?
•
•
•
•
•
Before calling service personnel