Troubleshooting Procedures
2.5.3 Procedure 3 Connector Check and Replacement Check
USB FDD is connected to USB port on system board or USB/Sound board. The connection of
the cable and board may be defective. Otherwise, they may be faulty. Disassemble the
computer following the steps described in Chapter 4, Replacement Procedures and perform
the following checks.
USB FDD can be connected to the following 3 ports.
(System board x 1 ports, USB/RGB board x 1 port and USB board x 1 port (or Modem/USB
board).
Check 1 Make sure USB FDD is firmly connected to USB port. If the connection is loose,
connect firmly and repeat Procedure 2. If the problem still occurs, go to Check 2.
2-32 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
To Next Page
Loading...
