EasyManuals Logo

Toshiba Tosvert VF-S15 Manual

Toshiba Tosvert VF-S15
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
E6582051
- 53 -
6.8.
Access to inverter parameter
When access to inverter parameter, set “1” to the PNU. The communication number of the inverter
parameter is set to the sub index IND.
Refer to the inverter instruction manual about the communication number and unit.
Notes
When you use this method for parameter writing, the value is written to the EEPROM.
6.8.1. Examples of reading or changing inverter parameter
6.8.1.1. Example1. Reading the basic parameter (
cmod
(command mode selection))
AK = 6 (Request parameter value (array))
SPM = 0
PNU = 1
IND = 0x0003 (
cmod
communication number)
PKE
0
1
1
0
0
0
0
0
0
0
0
0
0
0
0
1
6
0
0
1
Requirement
PKW PZD
PKE IND PWE
60
01
00
03
00
00
00
00
・・・
・・・
Response (Value: 0x0001 = Operation panel))
40
01
00
03
00
00
00
01
・・・
・・・
6.8.1.2. Example2. Reading the basic parameter (
sr1
(Preset-speed frequency 1))
AK = 6 (Request parameter value (array))
SPM = 0
PNU = 1
IND = 0x0018 (
sr1
communication number)
PKE
0
1
1
0
0
0
0
0
0
0
0
0
0
0
0
1
6
0
0
1
Requirement
PKW PZD
PKE IND PWE
60
01
00
18
00
00
00
00
・・・
・・・
Response (Value: 0x1770 (= 6000 -> 60.00Hz *))
40
01
00
18
00
00
17
70
・・・
・・・
* 0x1770 as reading value of Preset-speed frequency 1is 0x1770 = 6000 (decimal number)
Since the unit of Preset-speed frequency 1 is 0.01Hz, setting value is 6000
×
0.01 = 60.00Hz.

Table of Contents

Other manuals for Toshiba Tosvert VF-S15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba Tosvert VF-S15 and is the answer not in the manual?

Toshiba Tosvert VF-S15 Specifications

General IconGeneral
CategoryInverter
Control MethodV/f control, Sensorless vector control
Cooling MethodForced air cooling
ModelTosvert VF-S15
Protection FeaturesOvercurrent, Overvoltage, Undervoltage, Overheat
Communication OptionsModbus RTU
Overload Capacity150% for 1 minute
Braking UnitBuilt-in braking transistor
Output Voltage3-Phase, same as input voltage
Operating Temperature-10 to +50°C (14 to 122°F)
Storage Temperature-20 to 65°C (-4 to 149°F)
Humidity5 to 95% RH (non-condensing)
AltitudeUp to 1000m above sea level
Input Voltage3-Phase 200 to 240 VAC, 3-Phase 380 to 480 VAC
WeightVaries depending on model (e.g., 0.8 kg to 16 kg)

Related product manuals