Toyopuc PC3/PC2 Ethernet Driver
15. Now that the connection is configured, click Sub-Net Mask and Gateway IP Address. These values
should be set by the IT Manager. For less complex networks, match the sub-net mask and gateway IP
address that are configured in the PC's network configuration.
16. Click OK when finished.
17. Click on Timers. This dialog allows the Ethernet connection to reset if a network error forces a
dropped connection between the server and the device. By default, the Non-Reception Timer is set to
Disable (which means permanent waiting).
www. kepware.com
45
To Next Page
Loading...