85
Chapter 11
Customize Your Network Settings
11. 8. 3. Method 3: Enter the router’s PIN on your client device
Use this method if your client device asks for the router’s PIN.
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced > Wireless > WPS, and click Method Two--PIN.
3. Take a note of the Current PIN of the router. You can also click the Generate button
to get a new PIN.
4. Enter the router’s PIN on the client device. (The default PIN is also printed on the
label of the router.)
5. The WPS LED flashes for about 2 minutes during the WPS process.
6. When the WPS LED is on, the client device has successfully connected to the router.
Note:
1. The WPS LED on the router will light on for five minutes if the device has been successfully added to the network.
2. The WPS function cannot be configured if the wireless function of the router is disabled. Please make sure the
wireless function is enabled before configuring WPS.
11. 8. 4. Method 4: Enter the client device’s PIN on the router
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Advanced > Wireless > WPS page, and click Method Two--PIN.
3. Select Client’s PIN.
4. Enter the client device’s PIN, and then click the Connect button.
5. Device has been added successfully! or the similar information will appear on the
web management page, which means the client device has successfully connected
to the router.
To Next Page
Loading...
