EasyManua.ls Logo

TP-Link JetStream TL-SG3424 - Page 64

TP-Link JetStream TL-SG3424
262 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 5-
11 Traffic Statistics
The following entries are displayed on this screen:
Auto Refresh
Auto Refresh: Allows you to Enable/Disable refreshing the Traffic Summary
automatically.
Refresh Rate: Enter a value in seconds to specify the refresh interval.
Statistics
Port: Enter a port number and click the Select button to view the traffic
statistics of the corresponding port.
Received: Displays the details of the packets received on the port.
Sent: Displays the details of the packets transmitted on the port.
Broadcast: Displays the number of good broadcast packets received or
transmitted on the port. The error frames are not counted in.
Multicast: Displays the number of good multicast packets received or
transmitted on the port. The error frames are not counted in.
Unicast: Displays the number of good unicast packets received or
transmitted on the port. The error frames are not counted in.
Alignment Errors: Displays the number of the received packets that have a bad
Frame Check Sequence (FCS) with a non-integral octet
(Alignment Error). The length of the packet is between 64 bytes
and 1518 bytes.
UndersizePkts: Displays the number of the received packets (excluding error
packets) that are less than 64 bytes long.
Pkts64Octets: Displays the number of the received packets (including error
packets) that are 64 bytes long.
Pkts65to127Octets: Displays the number of the received packets (including error
packets) that are between 65 and 127 bytes long.
Pkts128to255Octets: Displays the number of the received packets (including error
packets) that are between 128 and 255 bytes long.
Pkts256to511Octets: Displays the number of the received packets (including error
packets) that are between 256 and 511 bytes long.
Pkts512to1023Octets: Displays the number of the received packets (including error
packets) that are between 512 and 1023 bytes long.
PktsOver1023Octets: Displays the number of the received packets (including error
packets) that are over 1023 bytes.
Collisions: Displays the number of collisions experienced by a port during
packet transmissions.
55

Table of Contents