15.2.3 NTDP Config
On this page you can configure NTDP globally.
Choose the menu Cluster→NTDP→NTDP Config to load the following page.
Figure 15-8 NTDP Config
The following entries are displayed on this screen:
¾ Global Config
NTDP: Select Enable/Disable NTDP for the switch globally.
NTDP Interval Time: Enter the interval to collect topology information. The default is 1
minute.
NTDP Hops: Enter the hop count the switch topology collects. The default is 3
hops.
NTDP Hop Delay: Enter the time between the switch receiving NTDP request
packets and the switch forwarding NTDP request packets for the
first time. The default is 200 milliseconds.
218
To Next Page
Loading...
