Mopping
7
2. Remove the rubber plug and
add water to the water tank.
1. Take out the dustbin
and water tank.
3. Wipe the water tank with
a clean, dry cloth.
4. Install the washable
mop cloth and the mop
cloth mount.
5. Re-install the dustbin
and water tank.
2. Remove the washable
mop cloth.
4. Sun dry the mop cloth
and mop cloth mount.
3. Clean the mop cloth.
• Vacuum oors before starting the rst mopping cycle.
• To prevent wetting the carpet, add a block zone, virtual wall, or carpet area
on the Tapo app.
• The ability to cross obstacles is reduced when mopping.
• It is recommended to wash the mop cloth after each use.
99
1. Remove the mop cloth mount.
To prevent corrosion, do NOT add any
cleaning agents. Only use cool or room
temperature water and be careful not to
wet the metal contacts.
To Next Page
Loading...
