Question 3. How to avoid signal interference between adjacent devices
Installation method (DUT relative position
Installation spacing required for adjacent road work Installation space required for non-adjacent road work
Installation distance without interference from adjacent equipment:
,
The maximum value is the final result.
The following is the case where the fixed transmission distance is
1 KM to ensure 10M throughput (2 channels
Stay above 2 m. The distance can be adjusted according to actual conditions.
,
Calculate all obstacles
,
then wireless
,
,
In actual use, when multiple devices need to be installed centrally in a certain area, the signals between
adjacent devices interfere with each other and cause performance impact.
,
,,
It is recommended that each equipment be installed at a safe distance
to avoid
The acceptable radius is 8.485m. Assuming that the obstacle height h is 10 m, the
CPE erection height should be
higher than. Similarly 1 8 . 4 8 5 m is the result at
,
IPC) is the standard to
calculate the dense security of the same prototype based on the isolation of different installation methods.
,
Side by
side,
vertical,
back to back
8m
0.25m
0.25m
2.1m
67m
distance
37m
settings)
1.2m
8m
twenty three
Machine Translated by Google
To Next Page
Loading...
