63
Chapter 11
Specify Your Network Settings
solution for networks that do not support native dual-stack, where both IPv6 and IPv4
run independently.
1. Visit http://tplinkmodem.net, and log in with your TP-Link ID or the password you
set for the router.
2. Go to Advanced > Network> IPv6 Tunnel.
3. Enable IPv6 Tunnel.
4. Specify a tunneling mechanism and select a WAN connection.
5. Save the settings.
11. 9. USSD
Unstructured Supplementary Service Data (USSD) is a technology that allows you to
communicate with your service provider using short codes. It usually consists of a
number that starts with * and ends with #. You can query various services on this page.
1. Visit http://tplinkmodem.net, and log in with your TP-Link ID or the password you
set for the router.
2. Go to Advanced > Network> USSD.
3. Enter the USSD request supported by the carrier and click Send. You will see the
message returned from the carrier in the USSD Result box.
To Next Page
Loading...
