TP-Link TL-SG2452 - Appendix: Default Parameters

User Guide 758
Configuring IPv4 IMPB Appendix: Default Parameters
6
Appendix: Default Parameters
Default settings of DHCP Snooping are listed in the following table:
Table 6-1 DHCP Snooping
Parameter Default Setting
Global Config
DHCP Snooping Disabled
VLAN Config
Status Disabled
Port Config
Maximum Entry 512
Default settings of ARP Detection are listed in the following table:
Table 6-2 ARP Detection
Parameter Default Setting
Global Config
ARP Detect Disabled
Validate Source MAC Disabled
Validate Destination MAC Disabled
Validate IP Disabled
VLAN Config
Status Disabled
Log Status Disabled
Port Config
Trust Status Disabled
Limit Rate 100 pps