TP-Link TL-SL2210WEB - Port Statistic

37
Gigabit Web Smart Switch User's Guide
TL-SG2109WEB/TL-SL2210WEB/TL-SL2218WEB/TL-SL2428WEB/TL-SL2452WEB
Notice:
If you haven’t set the static MAC address, you can't enable all of the port
security, which will result in an inability to manage the switch.
Flow Control
¾
: Indicates whether the ow control is enabled or disabled.
Duplex Mode
¾
: Possible led values are Auto, 10M HD, 10M FD, 100M
HD, 100M FD and 1000M FD (Giga port support), "HD" stands for half-
duplex and "FD" stands for full-duplex. “Auto” means auto negotiation.
Further explanation:
1) By operating on fields in the All Ports line expediently, you can set the
values of all ports in the corresponding field. Some other setting pages
offer the same function.
2) Parameters of Trunk member ports are congured with default value (see
the Appendix B table) and cannot be congured here (see port 5 and 6 in
the gure for example). For SFP, the Duplex Mode is set to “1000M FD”
and cannot be modied.
5.3.2.2 Port Statistic
This page displays the port statistic, it contains the following entries:
Figure 5-22 Port Statistic