TP-Link TL-SL2210WEB - Switch IP Address

42
Gigabit Web Smart Switch User's Guide
TL-SG2109WEB/TL-SL2210WEB/TL-SL2218WEB/TL-SL2428WEB/TL-SL2452WEB
5.3.3.1 Switch IP Address
This page is showed as below:
Figure 5-26 Switch IP Address
MAC Address
¾
: Is firmed into switch in the manufacturing process; it is
sole and unchangeable.
DHCP Client
¾
: Indicates whether the DHCP function is enabled. If DHCP
client is enabled, the switch will obtain the IP address, netmask and default
gateway from the DHCP server automatically; otherwise, these three items
should be congured manually.
IP Address
¾
: Is necessary for switch management. The configuration of
switch IP address must be compliant with the subnet layout.
Default Gateway
¾
: Serves as the default destination when a packet whose
destination IP address is not within the switch’s subnet is to be forwarded.
Notice:
1) When DHCP client is enabled, the IP parameters are obtained
automatically from the DHCP server, so the “IP Address”, “Netmask” and
“Default Gateway” elds are disabled. These parameters can be queried
on the DHCP server.
2) The initial state of DHCP client is disabled and the initial IP address is
192.168.0.1.