45
Chapter 8 Manage Your Access Point
2 ) Select the correct Start date and time when daylight saving time starts at your
local time zone.
3 ) Select the correct
End date and time when daylight saving time ends at your
local time zone.
4 ) Click
SAVE.
8. 2. Control LEDs
The LEDs of access point indicate its activities and status. You can turn off the LEDs
when you don’t need them.
1. Visit
http://tplinkap.net, and log in with the password you set for the access point.
2. Go to
System > LED Control.
3. Turn off the LEDs when you don’t need them.
• If you want to turn off LEDs immediately, turn off
LED Status.
• If you want to turn off LEDs during a specific time period, follow the steps below:
1 ) Enable
LED Status and Night Mode.
To Next Page
Loading...
