29
Chapter 4
Wireless Settings
2 ) Within 2 minutes, enable WPS on your client.
3 ) A success message will appear on the WPS page when the device successfully
join the access point’s network.
• Connect via the WPS button on the access point
1 ) Press the WPS button on the back panel of the access point.
2 ) Within 2 minutes, enable WPS on your client. The client will connect to the access
point.
WLAN
On
TP-Link
MyHome
David
HomeNetwork
TP-Link_Home
TP-Link_Router
Test
4. 3. Check Advanced Wireless Settings (for Access
Point/Multi-SSID Mode)
You can check advanced wireless settings for the device. It is recommended that you
keep the default settings. Improper settings may affect network performance.
1. Visit http://tplinkap.net, and log in with the password you set for the access point.
2. Go to Wireless > Wireless Advanced.
3. Check the advanced settings of your wireless network.
To Next Page
Loading...
