28
Chapter 4
Wireless Settings
4. 2. Use WPS for Wireless Connection (for Access
Point/Multi-SSID Mode)
Wi-Fi Protected Setup (WPS) provides an easier approach to set up a security-protected
Wi-Fi connection.
1. Visit http://tplinkap.net, and log in with the password you set for the access point.
2. Go to Wireless > WPS.
3. Follow one of the following methods to connect your WPS-enabled client to the
access point’s Wi-Fi network.
• Connect via the client’s PIN
1 ) Click Client’s PIN.
2 ) Enter your client’s PIN, and then click CONNECT.
3 ) A success message will appear on the WPS page when the device successfully
join the access point’s network.
• Connect via the access point’s PIN
1 ) Click Access Point’s PIN.
2 ) Check your access point’s PIN. You can use the default PIN or generate a new
one.
3 ) Enter this PIN on your client for it to join the access point’s network.
• Connect via the Start button on the WPS page
1 ) Click the Start button on the WPS page.
To Next Page
Loading...
