2
Locate a suitable mounting site for your CPE. For choosing the best location,
select an elevated location where trees, buildings and large steel structures will
not obstruct the antenna signals and which offers maximum line-of-sight
propagation with the users.
Connect one end of an
Ethernet cable to the POE
port of the provided Power
Injector and the other end
of the Ethernet cable to the
LAN port of the CPE. Then,
connect the LAN port of the
Power Injector to a PC
using another Ethernet
cable. Finally, plug the
provided power adapter
into the DC jack on the
Power Injector, and the
other end to a standard
electrical wall socket.
Note
Please use only wired network connections to configure the AP.
djust the direction of your CPE for a best signal. Place the straps through the
slots on the back of the CPE and then around the
To Next Page
Loading...
