9
Connect one side of the TL-ANT24SP to the RP-SMA port of your CPE through
the TL-ANT24PT3.
Connect the other side of the TL-ANT24SP to the TL-ANT2424B.
Appendix 1:
1
External antenna connection
Configure the external antenna
2
Note
1. If you have an external antenna with the RP-SMA (male) port, you could
connect it to the RP-SMA port of your CPE directly.
2. If you don’t have any external antennas, you are recommended to use
TP-LINK products for outdoor solution. You could choose TL-ANT2424B
(external antenna), TL-ANT24SP (Surge Protector), and TL-ANT24PT3
(Pigtail Cable) to connect as the following steps:
Note
You will need to assign your computer a Static IP address within the same
range as the AP’s IP address. See the Troubleshooting T3 if you need
assistance.
To Next Page
Loading...
