7
Click Wireless >
Wireless Mode
Select Client
Enter TP-LINK_900008, the SSID
of the first AP you have configured
After successfully logging in, configure the other TL-WA5210G by following the steps
below.
2)
The Client Setting
Click Save at the bottom of this page.
C. Configuration for Repeater
To make sure the TL-WA5210G is under AP mode, please follow the steps below.
The AP will begin rebooting automatically after you click Save.
The AP will begin rebooting automatically after you click Save.
Note
You should change the default LAN IP address of the Client from
192.168.1.254 to 192.168.1.X (X can be any number from 2 to 253) to avoid
an IP conflict with the former AP. Here we choose 192.168.1.2 as an example.
Note
Click Save
Click Network
Enter 192.168.1.2 in the
IP Address field
Click Save
Select AP
Click Operation Mode
To Next Page
Loading...
