141
450Mbps High Power Wireless N Router
3) The WPS LED on the router will light green for five minutes if the device has been
successfully added to the network.
The WPS function cannot be configured if the Wireless Function of the router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.
5.3.3.3. Wireless Security
Go to “Setting→Wireless→Wireless security”, and then you can configure the security
settings of wireless network.
Figure 5-7 Wireless Security
There are three wireless security modes supported by the Router: WPA/WPA2-Personal,
WPA/WPA2 - Enterprise and WEP (Wired Equivalent Privacy). Each security option has its own
settings as described follows:
Disable Security
The wireless security function can be enabled or disabled. If disabled, the wireless stations will
be able to connect this device without encryption. It is recommended strongly that you choose
one of other options to enable security.
WPA/WPA2 – Enterprise
It’s based on Radius Server.
To Next Page
Loading...
