8
450Mbps High Power Wireless N Router
2. Is the TCP/IP configuration for your PC correct?
Note:
If the router's IP address is 192.168.0.1, your PC's IP address must be within the range of
192.168.0.2 ~ 192.168.0.254.
3. Try the IP address 192.168.0.1.
Note:
If the LAN IP of the modem connected with your router is 192.168.0.x, the default LAN IP of the
router will automatically switch from 192.168.0.1 to 192.168.1.1 to avoid IP conflict. Therefore,
in order to verify the network connection between your PC and the router, you can open a
command prompt, and type ping 192.168.1.1, and then press Enter.
2.4 Connecting the router
2.4.1 Before you start
Before installing the Router, please make sure your broadband service provided by your ISP is
available. If there is any problem, please contact with your ISP.
Please choose the operation mode you need and carry out the corresponding steps. There are
three operation modes supported by this router: Router, Range Extender and Access Point.
Please install the Antennas first by following the steps shown below before your start to use the
router.
To Next Page
Loading...
