43
Chapter 6
Customize Your Network Settings
7. Enter the Default Gateway of the DHCP server.
8. Select a Device Type from the drop-down list to decide which kind of device will
obtain IP address from this pool.
9. Select an option from the drop-down list and enter the option value.
10. Select a Group from the drop-down list.
11. Select Enable This Entry.
12. Click OK.
Note: If you want to disable this entry, click the Bulb icon.
6. 2. Configure IPv6 LAN Settings
Based on the IPv6 protocol, the router provides two ways to assign IPv6 LAN addresses:
• Configure the RADVD (Router Advertisement Daemon) address type
• Configure the DHCPv6 Server address type
6. 2. 1. Configure the RADVD Address Type
1. Visit http://tplinkmodem.net or http://192.168.1.1, and log in with the password you
set for the modem router.
2. Go to Advanced > Network > LAN Settings.
3. Select IPv6 to configure IPv6 LAN parameters.
1 ) Select RADVD as the address type to make the router assign IPv6 address
prefixes to hosts.
Note:
To Next Page
Loading...
