44
Chapter 6
Customize Your Network Settings
Do not select the Enable RDNSS and Enable ULA Prefix check boxes unless required by your ISP. Otherwise
you may not be able to access the IPv6 network. For more information about RDNSS and ULA Prefix, contact
our technical support.
2 ) Keep Site Prefix Type as the default setting Delegated. If your ISP has provided
a specific IPv6 site prefix, select Static and enter the prefix.
3 ) Keep WAN Connection as the default settings.
4. Click Save to make the settings effective.
6. 2. 2. Configure the DHCPv6 Server Address Type
1. Visit http://tplinkmodem.net or http://192.168.1.1, and log in with the password you
set for the modem router.
2. Go to Advanced > Network > LAN Settings.
3. Select IPv6 to configure IPv6 LAN parameters.
1 ) Select DHCPv6 Server as the address type to make the router assign IPv6
addresses to hosts.
2 ) Specify the Starting/Ending IPv6 Address for the IPv6 suffixes. The router will
generate IPv6 addresses within the specified range.
3 ) Keep Address Lease Time as the default setting.
4 ) Keep Site Prefix Type as the default value Delegated. If your ISP has provided a
specific IPv6 site prefix, select Static and enter the prefix.
5 ) Keep WAN Connection as the default setting.
4. Click Save to make the settings effective.
To Next Page
Loading...
