59
Chapter 6
Customize Your Network Settings
3. Take a note of the current PIN of the router. You can also click the Generate button
to get a new PIN.
4. Enter the router’s PIN on the client device. (The default PIN is also printed on the
label of the router.)
5. The WPS LED flashes for about 2 minutes during the WPS process.
6. When the WPS LED is on, the client device has successfully connected to the router.
Note:
1. The WPS LED on the router will light on for five minutes if the device has been successfully added to the network.
2. The WPS function cannot be configured if the wireless function of the router is disabled. Please make sure the
wireless function is enabled before configuring WPS.
Method 4: Enter the client device’s PIN on the router
1. Visit http://tplinkmodem.net or http://192.168.1.1, and log in with the password you
set for the modem router.
2. Go to Advanced > Wireless > WPS, and click PIN Number.
3. Enter the Client’s PIN.
4. Then click the Connect button.
5. Device has been added successfully! or the similar information will appear on the
web page, which means the client device has successfully connected to the router.
6. 10. Configure MAC Filter Settings
You can toggle on to control wireless access using the MAC address of individual
devices.
1. Visit http://tplinkmodem.net or http://192.168.1.1, and log in with the password you
set for the modem router.
2. Go to Advanced > Wireless > MAC Filter.
3. Enable the Wireless MAC Filtering function.
To Next Page
Loading...
