To Next Page

To Previous Page

Turning The Analyzer Off

Always: - Before turning off return the instrument to a clean air environment

and allow the Carbon Monoxide level to return to below 10ppm and the

Oxygen level to return to 20.9% (± 0.5%)

If the pump is running tap “Stop Pump” to turn

the pump off. If the CO is above 10ppm or the

O2 is below 19% the Stop Pump icon will be

grreyed out. Once the O2 and CO levels are

within necessary limits the Stop Pump icon will

be active.

Once the pump is off close the app or discon-

nect from the DC710. Press and hold the power

key on the DC710 to turn the analyzer off.

If the app is disconnected before the CO is

below 10ppm or the O2 is above 19% and the

power key is held down to turn the analyzer off,

the pump will continue to run until the CO and

O2 are within limits. Once within limits the

DC710 will auto power down.

Questions and Answers:

Need help?

Do you have a question about the TPI DC710 and is the answer not in the manual?

TPI DC710 Specifications

General