T+A HV Series User Manual

19
Source names
menu item
At this menu item you can activate and disable external sources, and assign
a plain text name to each source; this name then appears in the screen
displays.
When you call up this menu item using the  button, a list of all the
external and internal sources of the SDV 3100 HV appears. Each source is
followed by the assigned name, or if you have disabled the source concerned
the note 'disabled'.
If you want to activate / disable a source, or change the plain text name,
navigate to the appropriate line.
To activate a source, press the green  button; a long press on the
green  button disables the source.
To change the plain-text name, move to the appropriate line and press the
button. Now use the alpha-numeric keypad of the F3100 to change the name
as required, then confirm your choice with ; this saves the settings for
that source.
The  button is used to switch between numeric and alpha-numeric
input, and between capitals and lower-case letters.
Letters can be erased by pressing the -button.

The source name can only be changed for the external sources.
If you should wish to restore the factory default source name, erase the whole
name before saving the empty field with the  button: this action resets
the display to the standard source names.
The only available method of entering the name is to use the alpha-numeric
keypad on the remote control handset.
sub point
Pass through
If you wish to connect a device with its own volume control (e.g. TV set), this
menu point can be used to disable the volume control of the SDV 3100 HV for
the Analog IN 1 or Analog IN 2 input (pass-through mode).

You should only select this setting if a device with its own volume control is
connected to the unit. Ensure that the volume of the source device is turned
down to zero before connecting it to the SDV 3100 HV, otherwise the
speakers connected to it may be ruined through overloading.
Headphone mode
menu item
The SDV 3100 HV detects headphones automatically.
In the “Automatic” setting the pre-amplifier output is automatically
switched off when headphones are connected. If you wish to be able to
control these outputs separately, select the “Manual” setting.
Left rotary knob
menu item
Under this menu item you can define the main function of the left rotary
knob. The set main function can be operated without pressing the knob first.
For the second function, the knob must be pressed briefly first.
Select "Volume/Source" when volume control should be the main function or
select "Source/Volume" if source selection is the main function.
Display Brightness
menu item
(screen brightness)
At this point you can adjust the brightness of the integral screen to suit your
personal preference for normal use.

We recommend that brightness settings 6 and 7 should only be used when
the screen is difficult to read due to very bright ambient light.
A lower brightness setting will extend the useful life of the screen.

T+A HV Series Specifications

General

Brand	T+A
Model	HV Series
Category	Amplifier
Language	English