T+A HV Series - The Configuration for a Wired Ethernet LAN or Power-Line LAN Connection; Setting the Parameters for a Wired Network

57
The Configuration for a Wired Ethernet LAN or Power-Line LAN connection
Setting the Parameters for a
Wired Network
 Connect the SDV 3100 HV to an operational network or Power-Line modem
using the LAN socket on the back panel.
 Switch the SDV 3100 HV on, Open the System Configuration menu by
pressing the  button on the remote control handset or the 
button on the front panel of the SDV 3100 HV.
 Use the  /  buttons to select the menu point “Network”, then
confirm your choice with the  button.
 If necessary select under the menu item "Interface" the option "LAN"
 You should now see the menu reproduced below, displaying the network
parameters.
 You can now select the individual menu points and adjust them to match
your network conditions. The illustration below shows the possible button
inputs after each menu item.
Possible entries
 / : Switching ON / OFF
(0...9): Numeric input, separating dots are automatically generated;
input limited to valid addresses
(0...9, A...Z): Alpha-numeric input and special characters.
IP - separating dots must be entered as special characters.

The parameters illustrated above are only typical values.
Addresses and settings may require different values for your network.