Many features of the SDV 3100 HV are software based. Updates and new
features will be made available from time to time. For updating the firmware
of the SDV 3100 HV there is a convenient method which requires an existing
Internet connection
If you are operating the SDV 3100 HV in conjunction with a PDT 3100 HV, the
machine can also be updated via the HLink connection.
The wiring diagram for the machine is shown in 'Appendix A'.
The following section describes the exact method of updating the firmware in
detail.
Updating the firmware via the SDV 3100 HV’s Internet connection
The basic requirement is a functioning network with router and access to
a broadband Internet connection; the system must be operating.
Switch the machine on.
Call up the System menu by pressing the button on the front panel.
Rotate the SELECT knob on the front panel to select the “Device info”
menu point, and confirm your selection by pressing the SELECT knob.
If the SDV 3100 HV is connected to a PDT 3100 HV via the HLink
connection, the Select Device menu appears at this point. In this case
select the device to be updated by turning the SELECT knob, then press
the SELECT knob to confirm your choice.
(If the SDV 3100 HV is not connected to a PDT 3100 HV, the Software
Update menu of the SDV 3100 HV appears directly.)
Select the “Update” menu point by rotating the SELECT knob, then press
the SELECT knob to confirm your choice.
The Select option “WEB” should now be active (highlighted).
The firmware update can now be started by pressing the SELECT knob.
The screen displays the current state of progress of the update.
Once the update has been completed (duration around ten minutes) the
device automatically switches itself off and restarts.
When the machine has restarted, the update is complete.
To ensure that the update was successful, access the “Device Info” menu
point mentioned above, and check the new firmware status.
It is also possible to carry out the update process using the F3100 remote
control handset, as an alternative to operating the machine directly. The
method of operating the menu using the handset is described in the chapter
entitled “Basic settings of the SDV 3100 HV” (Using the remote control
handset).
To Next Page
Loading...
Need help?
General
