To Next Page

To Previous Page

D/A-Converter settings of the SDV 3100 HV

A number of special settings are available for the SDV 3100 HV D/A converter; they are designed to fine-tune the

characteristics of your amplifier to suit your listening preferences.. This settings are described in detail in the

following chapter.

Calling up and operating the

 To call up the menu, press and hold the  button on the F3100.

 To call up the menu on the front panel, touch the  button and select

the menu item "D/A configuration" with the SELECT knob and press it to

access the menu.

 When you open the menu, the following Select points appear on the

screen:

Using the front-panel controls:

 The SELECT knob is used to select any item within the menu system.

 To change a selected menu item, press the SELECT knob to confirm your

choice, then adjust the value by rotating the knob.

 After making the adjustment, press the SELECT knob again to adopt the

new setting.

 You can interrupt the process at any time by touching the  button; in

this case any changes you have made are discarded.

 Holding the SELECT knob pressed in takes you one level further down in

the menu system.

 Touch the  button again to quit the menu.

Using the remote control handset:

 Use the  /  buttons to select an item in the menu.

 If you wish to change a selected menu item, first press the

-button, and then use the  / -buttons to alter it.

 After making the change, press the -button again to accept the

new setting.

 You can press the -button at any time to interrupt the process; the

change is then abandoned.

 Press the  button again to leave the menu.

T+A HV Series User Manual

Questions and Answers: