T+A HV Series User Manual

37
Starting playback
Press the  button on the remote control handset or the machine’s
front panel to start playback.
Stopping playback
Pressing the  button halts playback.
Skipping tracks
A brief press on the  /  buttons during playback causes the
device to jump to the previous or next piece of music within the current
playlist.
Playback of directories
In addition to the facility to play back
individual folder content, it is also
possible to play back entire
directories. This is accomplished by
selecting the folder of the directory
to be played, then pressing the
 button to start playback.
Playback commences with the first
entry in the list of content to be
played. If an entry in the list should
contain a folder with additional sub-
folders, the content of the lowest
folder is always played first. This is
followed by the content of the next
higher folder level, etc. (see diagram
right).
Search function
When you are navigating through lists you can call up the SDV 3100 HV `s
letter search function at any time by briefly pressing the  button. The
screen now displays the message “Search”. While this is on the screen, enter
up to eight letters or numerals using the remote control handset; the letters
assigned to the numeric buttons are printed below the buttons. To obtain a
particular letter, press the appropriate button repeatedly until the correct
letter appears on the screen. Before entering the next character you have to
wait until the cursor is displayed again. Press the  button to erase any
letter.
After pressing the  button or after a brief delay with no further input
the SDV 3100 HV moves to the first entry in the list which starts with the
characters you entered.

If the text searched for is not found the best matching result will be shown.
You can abort the search using the -button.
The function searches only the current folder. Eventually existing subfolders
are ignored.
Front panel display

The SDV 3100 HV provides different screen displays for the UPnP/DLNA
source.
A long press on the –button on the remote control handset is used to
switch between the display modes.
 Large-format display:
Enlarged display of the most important information, clearly legible even
from a distance
 Detail display:
Small-text display showing a large number of additional information
points, e.g. bit rate etc.

T+A HV Series Specifications

General

Brand	T+A
Model	HV Series
Category	Amplifier
Language	English