56
Alpha-numeric entry
At certain points, e.g. for entering server names or passwords, it is necessary
to input series of characters (strings). At such points you can enter letters,
numbers and special characters by repeatedly pressing the numeric buttons
on the F3100 remote control handset, as when writing SMS news. The
assignment of letters to the buttons is printed below the buttons. Special
characters can be accessed using the and buttons:
0 + - * / ^ = { } ( ) [ ] < >
. , ? ! : ; 1 \ " ' _ @ $ % & # ~
Use the button for toggling between numbers, capitals and lower-
case letters. The bottom line of the screen shows which input mode is
currently selected.
At certain points (e.g. DNS server name) it is possible to enter both an alpha-
numeric string and an IP address. At these points an IP address should be
entered like a string (with separating dots as special characters). In this case
an automatic check for valid address ranges (0 … 255) is not carried out.
Once you have correctly set all the parameters, select the menu item 'Store
and exit?', then press the button. This action causes the SDV 3100 HV
to accept the settings, and you should see the available network media
sources (Internet radio, UPnP-AV server, etc.) displayed in the main menu.
Interrupting the menu
without storing the settings
At any time you can leave the network configuration menu without making any
changes to the network settings: this is done by pressing the button,
which takes you to the menu item 'Store and exit?'. If you wish to quit at this
point without saving, use the / buttons to select the ‘Discard
and exit?’ menu item, then confirm with the button.
To Next Page
Loading...
Need help?
General
