98
13. Install the coolant sensor connector to the coolant
sensor; then connect the coil connectors to the coils;
then install the engine oil pressure switch connector
to the engine oil pressure switch that is located near
the engine oil filter; then attach the engine ground
located above the engine oil pressure switch.
MOD556
MOD557
14. Install the driver-side coolant hose to the engine;
then install the coolant hose above the starter; then
install the coolant hose near the engine intake.
MOD551B
MOD553A
MOD555A
15. Remove the suitable clamps that were used to mini-
mize coolant leakage.
16. Connect the starter wire (A) and start relay wire (B).
MOD538
17. Install the inner clutch cover; then install the retain-
ing ring near the PTO securing the inner clutch cover
to the engine; then near the transaxle input shaft
install the four cap screws securing the inner clutch
cover to the transaxle. Tighten the inner clutch cover
to transaxle cap screws to 8 ft-lb (10.9 N-m).
To Next Page
Loading...
