133
High: A high voltage condition has been detected.
Low: A low voltage condition has been detected.
Intermittent: An intermittent circuit condition has been detected.
Open: An open circuit condition has been detected.
* After correcting the condition, cycle the key switch On-Off-On.
**After correcting the condition, cycle the key switch On-Off-On, start the
engine and drive vehicle, then cycle the key switch On-Off-On.
U0100 Lost Communication with ECM The ECM CAN circuit or its interconnect harness is intermittent or
has failed.
Correct condition*
U0155 LCD Gauge to ECM CAN Communication
Lost
The LCD gauge CAN circuit or its interconnect harness is
intermittent or has failed.
Correct condition*
U1000 Vehicle Not Registered or Invalid PIN
Entered
A valid registration PIN has not yet been entered Enter the correct
registration PIN*
U1001 Vehicle Not Registered, Engine Hours
Exceed 5 Hours
A valid registration PIN has not yet been entered Enter the correct
registration PIN*
FUEL OFF Tilt Sensor Activation Code
The chassis tilt sensor has been activated. Correct condition*
Display Fault Description Possible Cause Fault Recovery Method
To Next Page
Loading...
