14
MOD097A
3. Install the rubber boot making sure it is sealed
around the bulb and connect the wire harness.
MOD098A
4. Adjust the headlight (see Checking/Adjusting Head-
light Aim in this sub-section.
Taillight/Brake Light Assembly
If one or more individual LED bulbs are not working, the
taillight/brake light assembly must be replaced.
MOD096
To replace the taillight/brake light assembly, use the fol-
lowing procedure:
1. Remove the four screws from the inner cargo box
side panel, two rear tie-down screws and one tailgate
latch bail screw; then remove the six screws from the
underside of the cargo box and remove the outer
cargo box side panel.
MOD114A
MOD115A
2. Remove screw (A); then flex the cargo box fender
away from the cargo box to access and remove screw
(B).
NOTE: A long extension with a T25 socket or long
T25 screwdriver will be needed to access screw (B).
MOD117A
MOD113
To Next Page
Loading...
