50
Preparation for Storage
Use the following procedure to prepare the ATV for storage:
1. Clean the seat cushion (cover and base) with a damp cloth and
allow to dry.
2. Clean the ATV thoroughly by washing dirt, oil, grass, and other for-
eign matter from the entire ATV. Allow the ATV to dry thoroughly.
DO NOT get water into any part of the engine or air intake.
3. Either drain the gas tank or add a fuel stabilizer to the gas in the gas
tank.
4. Clean the interior of the air filter housing.
5. Drain the carburetor float chamber.
6. Plug the hole in the exhaust system with a clean cloth.
7. Apply light oil to the upper steering post bushing and plungers of
the shock absorbers.
8. Tighten all nuts, bolts, cap screws, and screws. Make sure rivets
holding components together are tight. Replace all loose rivets.
Care must be taken that all calibrated nuts, cap screws, and bolts
are tightened to specifications.
9. Clean the ATV thoroughly.
10. Disconnect the battery cables (negative cable first); then remove
the battery, clean the battery posts and cables, and store in a clean,
dry area.
NOTE: For storage, use a battery maintainer or make sure the
battery is fully charged (see Battery section in this manual).
11. Store the ATV indoors in a level position.
CAUTION
Prior to storing the ATV, it must be properly serviced to prevent
rusting and component deterioration.
CAUTION
Avoid storing outside in direct sunlight and avoid using a plastic
cover as moisture will collect on the ATV causing rusting.
To Next Page
Loading...