51
Preparation after Storage
Taking the ATV out of storage and correctly preparing it will ensure
many miles and hours of trouble-free riding. Use the following proce-
dure:
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the cloth from the exhaust system.
3. Check all control wires and cables for signs of wear or fraying.
Replace if necessary.
4. Change the transmission lubricant.
5. Charge the battery; then install.
6. Connect the battery cables making sure to connect the positive
cable first.
7. Check the entire brake system (cables, shoes, etc.), all controls, and
brake light; adjust or replace if necessary.
8. Check the tire pressure. Inflate to recommended pressure as neces-
sary.
9. Tighten all nuts, bolts, cap screws, and screws making sure all cali-
brated nuts, cap screws, and bolts are tightened to specifications.
10. Make sure the steering moves freely and does not bind.
11. Check the spark plug. Clean or replace as necessary.
12. Check the air filter and the air filter housing. Clean or replace as
necessary.
To Next Page
Loading...