72
RT-SVX34V-EN
The Symbio™ 700 controls have input setpoint
potentiometers inside the control panel that are set at the
factory which will allow the unit to operate and maintain
system control. For specific job specifications:
• Verify that the control input potentiometers are set
according to the job specifications:
– DA Heat -_____Setpoint
– DA Cool - Fan SPD - _____Setpoint
– EXH Fan - _____Setpoint
• Inspect the unit for misplaced tools, hardware and
debris.
• Verify that all unit exterior panels—including the control
panel doors—are secured in place.
Startup
To Next Page
Loading...
