WSHP-SVX014J-EN
37
Figure 25. Low voltage single wire connection
Make connection for a single-wire by inserting a single wire
after stripping off the coating.
Figure 26. Low voltage stranded wire connection
Follow the steps to connect the stranded wire:
1. Release the spring with a dedicated screwdriver (blade
width 2.5 mm)
2. Insert the stripped cable as far as it gets inserted.
3. Complete the connection by removing the screwdriver.
Figure 27. Deluxe controls
Figure 28. TP1 connection type
Present on all 0.5 to 5 ton H/V units.
Installation
To Next Page
Loading...
