38
WSHP-SVX014J-EN
Figure 29. Deluxe controls with WSE or DX two-stage
TP2
1 - (Y2)Compressor/Cool stage 2
Figure 30. TP2 connection type
Only present on units with Deluxe 24V controls and either
2-speed compressor (DXV/H) or water side economizer
(WSE) coil DX and WSE on DLX.
Figure 31. Deluxe controls humidistat connections
between wires H1 and H2 in control box
Figure 32. Deluxe controls general alarm and
compressor disable
Deluxe board (1U1) connections
AL1, AL2 - Alarm Contact output
CD1, CD2 - Compressor Disable input (24Vac)
For installation, operation and programming see BAS-
SVX065*-EN (UC400-B) and BAS-SVX092*-EN (Symbio™
400-B).
WARNING
Hazardous Voltage!
Failure to disconnect power before servicing could
result in death or serious injury.
Disconnect all electric power, including remote
disconnects before servicing. Follow proper lockout/
tagout procedures to ensure the power can not be
inadvertently energized. Verify that no power is
present with a voltmeter.
WARNING
Proper Field Wiring and Grounding
Required!
Failure to follow code could result in death or serious
injury.
All field wiring MUST be performed by qualified
personnel. Improperly installed and grounded field
wiring poses FIRE and ELECTROCUTION hazards. To
avoid these hazards, you MUST follow requirements
for field wiring installation and grounding as
described in NEC and your local/state/national
electrical codes.
Installation
To Next Page
Loading...
