Installation - Mechanical
22 CLCH-SVX010A-EN
Outdoor Roof - Single Span
1. Ensure shipping split sections are aligned and pulled
together properly.
2. Add a bead of caulk along the length of the roof seams.
Install the pre-cut J-cap over the seam and secure with
#14 sheet metal screws on 12-inch centers.
Note: Use a polyurethane or equivalent caulk. It may be
necessary to clamp the joint together or pre-drill to
prevent separation when drilling with screws.
3. Apply caulk to end of J-cap to seal thoroughly.
Figure 20. Section split - indoor Figure 21. Section split - outdoor
Edge view
Section
trim cap
Wall
Trim
Hubcap
Roof
Ends of hubcaps
fit unter lip on trim
Hubcap
Section split
Roof
Section split
Wall
Trim
Edge view
End of hubcap fits
under lip on trip
Trim
Hubcap
Section split
Trim
Figure 22. Outdoor roof assembly - single span
Add caulking before
installing J cap
Joining cap
4-in. x 1/4-in. gasket
#10 x 1-in. self-tapping screw
Roof panel
section split
2 3/4-in. wide joining strip
#8 x 1-in. Phillips zip screw
3-in. x 1/8-in. neoprene gasket is
applied to metal joining strip. Apply
gasket to metal strip before installation.
Roof split outdoor unit
To Next Page
Loading...
