Trane CWCS User Manual

22
Set time
Cooling:
1 hour
1¢J
2¢J
SLEEP ON
SLEEP time setting
SLEEP time setting
SLEEP ON
Heating:
2¢J
1¢J
1 hour
Set time
SLEEP OPERATION
About the SLEEP FUNCTION
To prevent excessive cooling during sleep, the SLEEP function automatically modifies the thermostat setting in accordance with the
time setting. When the set time has elapsed, the air conditioner completely stops.
¡·
During Cooling / Drying operation:
When the SLEEP is set, the thermostat setting is automatically
raised 1¢J every sixty minutes. When the thermostat has been
raised a total of 2¢ J, the thermostat setting at that time is
maintained until the set time has elapsed, at which time the air
conditioner automatically turns off.
¡·
During Heating operation:
When the SLEEP is set, the thermostat setting is automatically
decreased 1¢Jevery one hour.
The thermostat setting can decrease total 2¢J.
¡·
Operation Model:
1.While in the cooling model, whenever the SLEEP function is
started, the thermostat setting is automatically raised 1¢J.
Setting is raised 1¢J again after sixty minutes. The total raise
is 2¢J¡C
2.SLEEP function is not valid on FAN mode.
TO CLEAN AIR FILTER ELECTROSTATIC CLEANER(OPTIONAL)
To Clean Air Filter
2The function is valid only in POWER ON status.
1After press the "AIR CLEAN" button , the air clean function
is started.
Remote controller displays "CLEAN ".
Electrostatic Cleaner
execute air clean
function
cancel air clean
function
1When indoor fan operates over accumulated 200 hours,
SLEEP LCD will flash, it is time to clean air filter. After
cleaning, please press UNMANUAL AUTO button, it will
calculate fan operation hours from start again.
2SLEEP LCD will flash continuously if you don't press
UNMANUAL AUTO button.
3When clean air filter, less cooling efficiency and power
expend will happened before put air filter back.

Trane CWCS Specifications

General

Brand	Trane
Model	CWCS
Category	Air Conditioner
Language	English